Vermona VSR 3.2 is a rackmountable spring reverb device with a focus on simplicity and excellent sound. Like Vermona's other spring reverb products, the VSR 3.2 uses a spring tank made by specialist AccuBell (formerly Accutronics).

Over 70 years ago, spring reverbs were used to bring large reverberated 'cathedral' sounds into the homes of Hammond organ players. Since then, the sound has become classic and now you can find spring reverb devices in most studios around the world and as a built-in option on many guitar amplifiers.

The 'imperfection' of the spring reverb sound is what makes VSR 3.2 perfect for any kind of audio signal: organs, synthesizers, acoustic and electric guitars, vocals, (electronic) drums, whatever you like—it always adds that clashing and resonant yet musical and warm reverb sound.

VSR 3.2 provides a GAIN knob to adjust the incoming signal level before it hits the spring tank. The resulting reverb signal can be refined by a carefully calibrated TONE control and seamlessly added to the unaffected original signal via a dry/wet MIX knob—simple but effective!

VSR 3.2 has the same EFFECT STOP button and footswitch input as its predecessor, but adds a PRE/POST toggle to control whether EFFECT STOP cuts the signal path before or after the spring tank, giving you the option to have reverb trails either fade out or cut off abruptly.

Thanks to its well-shielded internal switching power supply the VSR 3.2 works smoothly anywhere in the world. In its 1U rack housing it doesn't take up much physical space, but it will create much acoustic space!

• Knobs: GAIN, TONE, MIX, OUTPUT level
• EFFECT STOP button with PRE/POST toggle to determine where signal path is cut
• Rear panel footswitch jack to trigger EFFECT STOP
• AccuBell Type 9 spring tank
• Inputs
  • Front panel: -40dBu maximum input level, 1MΩ impedance
  • Rear A: 0dBu maximum input level, 100kΩ impedance
  • Rear B: -20dBu maximum input level, 10kΩ impedance
• Outputs
  • A: 0dBu, 600 Ohm
    
  • B: -20dBu, 600 Ohm